• Open-end wrench 10/13 for mounting the holder (For some models, we recommend using a ratchet with a socket to make it easier to access the M8 screw.)
Step 1
Remove your left passenger peg (if present). On Yamahas, for example, the rider's seat must be removed.
Step 2
Position the brackets and screw them hand-tight into the holes where the pillion footrests were previously mounted using the supplied M8 screw.
Step 3
Insert your “Insta360 Invisible Selfie Stick” into the holders and secure it by tightening the thumbscrews.
Step 4
Align the selfie stick so it's not touching the motorcycle. Then tighten all screws. Important! The holders must be tightened to a maximum of 8 Nm to avoid damage.
Tip: Avoid loosening the M6 screw on the bracket again. This will ensure your basic setting is retained permanently.
Step 5
Done! Now screw your 360° camera onto the selfie stick and enjoy impressive third-person shots on your next ride.
Attention: We recommend not pulling out the last part of the selfie stick for better shots.
Have a safe ride and lots of fun with your RideMount!
